If you are running OMNIA as a service and do not have the Discovery Tool downloaded on your PC/Server. You can change the IP to a controller using the OMNIA Software. 

Open OMNIA Select Setup>Networking>Network Settings

Choose the correct Controller you would like to make network changes


Once you choose the controller. Make sure to verify the IP you would like to use is available by using Command Prompt. Example type: ping 192.168.100.1 -t
This will perform a continuous ping of the IP address. To cancel: cntrl+c



Fill in the lines for IP Address, Subnet Mask, and Gateway. Then Check the box to make it static. (NOTE: Do Not Select Safe IP) 
Type in your password. Default: masterkey
Select check mark to save. 

Was this article helpful? Yes No